6 Remove the controller board shield.
7 Unpack the memory card.
Warning—Potential Damage: Avoid touching the connection points along the edge of the card.
8 Insert the memory card until it clicks into place.
9 Attach the shield, and then attach the access cover.
10 Attach the connector cover.
11 If you removed a filter cover, then attach the cover.
12 Connect the power cord to the electrical outlet, and then turn on the printer.
CAUTION—POTENTIAL INJURY: To avoid the risk of
fire
or electrical shock, connect the power cord
to an appropriately rated and properly grounded electrical outlet that is near the product and easily
accessible.
Upgrading and migrating 273
To Next Page
Loading...
