3
Slide the width guide to the correct position for the size of the
paper you are loading.
Note: Use the paper size indicators on the bottom of the tray
to help position the guides.
4
Prepare the paper or specialty media for loading.
•
Flex the sheets back and forth to loosen them, and then
fan them. Do not fold or crease the paper. Straighten the
edges on a level surface.
•
Hold transparencies by the edges, and then fan them.
Straighten the edges on a level surface.
Note: Avoid touching the printable side of the
transparencies. Be careful not to scratch them.
•
Flex the stack of envelopes back and forth to loosen them,
and then fan them. Straighten the edges on a level surface.
5
Load the paper or specialty media.
Note: Slide the stack gently into the multipurpose feeder
until it comes to a stop.
•
Load only one size and type of paper or specialty media at
a time.
•
Make sure the paper fits loosely in the multipurpose feeder,
lies
flat,
and is not bent or wrinkled.
One‑sided (simplex) printing Two‑sided (duplex) printing
ABC
12
To Next Page
Loading...
