365
3-7. Other interior features
3
Interior features
GS_G_U
March 29, 2010 3:11 pm
n Programming a Rolling Code system (for U.S.A. owners)
If y
our device is Rolling Code equipped, follow the steps under the
heading “Programming the HomeLink
®
” before proceeding with the
steps listed below.
Locate the training button on the ceiling mounted garage door
opener motor. The exact location and color of the button may
vary by brand of garage door opener.
Refer to the operation manual supplied with the garage door opener
for the location of the training button.
Press the training button.
Press and release the vehicle’s programmed HomeLink
®
button
twice. The garage door may open.
If the garage door opens, the programming process is complete. If the
door does not open, press and release the button a third time. This third
press and release will complete the programming process by opening
the garage door.
The ceiling mounted garage door opener motor should now recognize
the HomeLink
®
transceiver and operate the garage door.
Repeat the steps above to program another rolling code system
for any of the remaining HomeLink
®
buttons.
STEP 1
STEP 2
STEP 3
To Next Page
Loading...
