MAINTENANCE
1
Replace the engine oil and oil filter every 12 months or 10,000 miles, or when the oil maintenance reminder appears,
whichever comes first.
2
NX 200t with towing package only.
SCHEDULED MAINTENANCE LOG
24 Months or 20,000 Miles
❏
Replace engine oil with 0W-20 oil; replace
oil filter
1
❑
Replace cabin air filter
❏
Reset oil maintenance reminder, if oil
was changed
❑
Reset scheduled maintenance reminder
❏
Rotate tires
❏
Visually inspect brake pads, calipers and rotors
❏
Inspect wiper blades
❑
Check installation of driver’s floor mat
❏
Road-test vehicle
If you drive primarily under any of
these special operating conditions,
perform these additional items:
Driving on dirt roads or on dusty roads:
❏
Inspect axle shaft boots
❏
Inspect ball joints and dust covers
❏
Inspect engine air filter
❏
Inspect steering linkage and boots
❏
Re-torque nuts and bolts of drive shaft (AWD)
❏
Tighten nuts and bolts on chassis
Towing a trailer
2
, using a car-top carrier
or heavy vehicle loading:
❏
Re-torque nuts and bolts of drive shaft (AWD)
❏
Tighten nuts and bolts on chassis
Driving on roads on which road salt has
been applied:
❏
Re-torque nuts and bolts of drive shaft (AWD)
30 Months or 25,000 Miles
Date: _______ Mileage: ________ Date: _______ Mileage: ________
❏
Inspect and adjust all fluid levels
❏
Reset scheduled maintenance reminder
❏
Rotate tires
❏
Visually inspect brake pads, calipers and rotors
❏
Inspect wiper blades
❑
Check installation of driver’s floor mat
❏
Road-test vehicle
Note: If 0W-20 was not used at last oil change,
or if you drive primarily under certain special
operating conditions, you should also replace
the engine oil with 0W-20 oil and replace the
oil filter. See page 44 for conditions that apply.
Some conditions require additional maintenance.
See below.
If you drive primarily under any of
these special operating conditions,
perform these additional items:
Driving on dirt roads or on dusty roads:
❏
Inspect axle shaft boots
❏
Inspect ball joints and dust covers
❏
Inspect engine air filter
❏
Inspect steering linkage and boots
❏
Re-torque nuts and bolts of drive shaft (AWD)
❏
Tighten nuts and bolts on chassis
Towing a trailer
2
, using a car-top carrier
or heavy vehicle loading:
❏
Re-torque nuts and bolts of drive shaft (AWD)
❏
Tighten nuts and bolts on chassis
Driving on roads on which road salt has
been applied:
❏
Re-torque nuts and bolts of drive shaft (AWD)
50 Scheduled Maintenance Log
14-TCS-08545_LexusWSG_NX200t_GUTS_2_0F_lm.indd 50 12/18/14 6:29 PM