Lexus ES300 - Page 87

Finish
INTERIOR EQUIPMENT
73
6. Test the operation of the HomeLink
R
by pressing the newly
programmed button. Check to see if the gate/device operates
correctly.
7. Repeat steps 1 through 6 for each remaining HomeLink
R
button to program another device.
Programming other devices
To program other devices such as home security systems,
home door locks or lighting, contact your authorized Lexus
dealer for assistance.
Reprogramming a button
Individual HomeLink
R
buttons cannot be erased, however, to
reprogram a single button, follow the procedure “Programming
the HomeLink
R
”.
(b) Operating the HomeLink
R
To operate the HomeLink
R
, press the appropriate HomeLink
R
button to activate the programmed device. The HomeLink
R
indicator light should come on. The HomeLink
R
continues to
send the signal for up to 20 seconds as long as the button is
pressed.
(c) Erasing the entire HomeLink
R
memory
(all three programs)
To erase all previously programmed codes at one time, press
and hold down the 2 outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase the programs stored
in the HomeLink
R
memory.
CAUTION
D When programming the HomeLink
R
Universal
Transceiver, you may be operating a garage door or
other device. Make sure people and objects are out
of the way of the garage door or other device to
prevent potential harm or damage.
D Do not use this HomeLink
R
Universal Transceiver
with any garage door opener that lacks the safety
stop and reverse feature as required by federal safety
standards. (This includes any garage door opener
model manufactured before April 1, 1982.) A garage
door opener which cannot detect an object (signaling
the door to stop and reverse), does not meet current
federal safety standards. Using a garage door
opener without these features increases risk of
serious injury or death.