Lexus GS200t 2016 - Battery

BATTERY TERMINAL TIGHTNESS AND
CHARGE
a)Checktheelectrolytelevel.Iftheelectrolytelevelislow, 
 checkthebatterycaseforleakage.
b)Checkthebatterycharge.Measuretheopen-circuit 
 batteryvoltagebetweentheterminals.Ifthevoltage 
 readingislessthan12.6volts,rechargethebattery.
NOTE:
Beforemeasuringthevoltage,turnofftheengineandall
electricalsystems.Wait60secondstoremovethesurface
charge.Iftheenginewasrunningbeforemeasuringthe
voltage,wait20minutesaftertheenginestopstoremove
thesurfacecharge.
c)Checkthatthebatteryterminalsareproperlyconnected 
 andthattheclampisrmlyinstalled.
   Terminals
   Hold-downclamp
d)Printoutbatterychargetest.
Gasolinevehicles
Hybridvehicles
1
2
WIRING AND HOSES
a)Checkthehoses,hoseconnectorsandvariousclamps 
 fortightness.
b)Visuallyinspecttheconditionofallharnessconnectors 
 andterminalsforproperinstallationandtightness.
3
GS200t/350/450h/F
INSPECTION DETAILS - A. ENGINE COMPARTMENT