TIRE SERVICE:
The Lexus LFA does not come equipped with spare tire; instead the vehicle is equipped
with a tire inflation kit. The kit, which is part of the tool kit stored in the rear cargo area,
contains a 12-volt air compressor, puncture sealant, an injector hose, an extension hose
for extracting the sealant from the container, a valve core tool, a spare valve core and
warning stickers.
Check the nature of the damage to the tire. The sealant is only to be used if the flat tire
is a result of a nail or screw type puncture to the tire. If damage is greater than a small
puncture in the main part of the tread area of the tire or if the tire shows signs of being
driven on when deflated, tow the vehicle to a Lexus dealer or authorized repair facility to
have the tire properly repaired.
If the inflation kit is to be used, fully deflate the tire and remove the valve core using the
valve core tool. Shake the sealant container vigorously for about 1 minute to ensure
proper mixing of the sealant. Attach the injector tube to the container, remove the tube
plug and attach the tube to the valve stem. Squeeze the sealant into the tire. Affix the
small round warning sticker to the center of the wheel to alert service personnel that
sealant has been applied to the tire. Reinstall the valve core and inflate the wheel using
the compressor. After inflating the tire to its proper pressure, drive the vehicle for about
3 miles to ensure sealant has properly coated the inside of the tire. Stop and recheck tire
pressure before allowing vehicle to proceed to repair facility for proper tire evaluation
and repair. The larger warning sticker is meant to be placed on the inside of the
windshield support pillar on the driver’s side to warn the driver to proceed with caution
at a speed not greater than 50 MPH to a Lexus dealer or authorized repair facility to get
the tire properly repaired.
To Next Page
Loading...
