CAR CARRIER LOADING AND TRANSPORTING:
The use of car carrier equipment is the only approved method of transporting the Lexus
LFA.
The curb weight for the LFA is 3,483 lbs.
The Lexus LFA has a standard ground clearance of 4.3 inches and an approach angle of
7.0 degrees. The average flatbed tow truck has a loading angle of 13 – 17 degrees with
the bed down on a flat level surface. Additional ramping is required to load a Lexus LFA
without causing damage. Clearance at the trailing end of the vehicle should always be
monitored as it is loaded.
The towing eye bolt must be used for loading of this vehicle as there are not any
attachment points under the vehicle. The eye bolt is located in the tool kit which is
stowed under a removable cover on the right side forward portion of the rear cargo area.
Eyebolts are available for purchase through any Lexus dealership parts department.
Other towing and tie-down equipment shown in this guide is available through AW
Direct, a AAA preferred supplier.
To Next Page
Loading...
