Lexus LS600hl - Page 426

412
4-5. Using the driving support systems
LS600h/LS600hL_EE(OM50D61E)
 The Blind Spot Monitor function is operational when
 The BSM main switch is set to on
 Vehicle speed is greater than approximately 16 km/h (10 mph).
 The Blind Spot Monitor function will detect a vehicle when
 A vehicle in an adjacent lane overtakes your vehicle.
 Another vehicle enters the detection area when it changes lanes.
 Conditions under which the Blind Spot Monitor function will not detect a
vehicle
The Blind Spot Monitor function is not designed to detect the following
types of vehicles and/or objects:
 Small motorcycles, bicycles, pedestrians etc.*
 Vehicles traveling in the opposite direction
 Guardrails, walls, signs, parked vehicles and similar stationary objects*
 Following vehicles that are in the same lane*
 Vehicles driving 2 lanes across from your vehicle*
*
: Depending on conditions, detection of a vehicle and/or object may occur.
CAUTION
 Cautions regarding the use of the system
The driver is solely responsible for safe driving. Always drive safely, taking
care to observe your surroundings.
The Blind Spot Monitor function is a supplementary function which alerts
the driver that a vehicle is present in the blind spot. Do not overly rely on
the Blind Spot Monitor function. The function cannot judge if it is safe to
change lanes, therefore over reliance could cause an accident resulting in
death or serious injury.
According to conditions, the system may not function correctly. Therefore
the driver’s own visual confirmation of safety is necessary.