190
4-3. Operating the lights and wipers
4-3.Operati ng the lights and w ipers
Operating the switch turns on
the lights as follows:
U.S.A.
Canada
1 The side marker, parking, tail,
license plate, instrument panel
lights, and daytime running lights
(P.190) turn on.
2 The headlights and all lights
listed above (except daytime run-
ning lights) turn on.
3 The headlights, daytime run-
ning lights (P.190) and all the
lights listed above turn on and off
automatically.
(When the engine switch is in
IGNITION ON mode.)
4 (U.S.A.) Off
(Canada) The daytime run-
ning lights turn on. (P.190)
■ Daytime running light system
● The daytime running lights illuminate
using the same lights as the parking lights
and illuminate brighter than the parking
lights.
● To make your vehicle more visible to
other drivers during daytime driving, the
daytime running lights turn on automati-
cally when all of the following conditions
are met. (The daytime running lights are
not designed for use at night.)
• The engine is running
• The parking brake is released
• The headlight switch is in the (Can-
ada only), or
*
position
*
: When the surroundings are bright
The daytime running lights remain on after
they illuminate, even if the parking brake is
set again.
● For the U.S.A.: Daytime running lights
can be turned off by operating the switch.
● Compared to turning on the headlights,
the daytime running light system offers
greater durability and consumes less
electricity, so it can help improve fuel
economy.
■ Headlight control sensor
Headlight switch
The headlights can be operated
manually or automatically.
Operating instructions
To Next Page
Loading...
