300360490_002_C0 - 09/2016 - © Leybold
7
When mounting the transducer avoid forced twisting or violent
opening. The housing can be mechanically damaged this way!
Overpressure in the vacuum system > 1 bar
Accidental or unintended opening of clamp elements under
stress can lead to injuries due to parts flying around!
Leaking process media can cause damage to your health.
Attend to the maximum pressure load of small flange connec-
tions (2,5 bar abs.). Use clamps that are suitable for overpres-
sure operation.
3.3 Electrical Connection
3.3.1 Operation with Display Unit
The transducer can be connected to suitable Leybold display units. For DU
series transducers display units of the DISPLAY and CENTER series are
available.
Do not connect or disconnect the transducer when the cable is
on circuit!
Connect the cable plug to the transducer and secure it. Connect the other end of
the cable to the display unit and secure the plug. Only now connect your display
unit to mains power or switch it on respectively.
To Next Page
Loading...