36
● TROUBLESHOOTING
Problem Solution
The wireless sensor may have initiated properly, and the data is
registered by the weather station as invalid, and the weather
statio must be reset.
With an open-ended paperclip, press the RESET button for 3
seconds to complete display the voltage. LED will flash every 20
seconds.
If LED will not flash every 20 seconds, take out the batteries and
wait 5 minute, while covering the solar panel to drain the voltage.
Put batteries back in and resync the weather station and resync
the weather station (Refer Page 10 RE-PAIRING SENSOR) with the
wireless sensor about 10 feet (3m) away .
The LED of the wirless sensor will flash every 20 seconds. If the
LED is still not flashing every 20 seconds, replace the new
batteries in the wireless sensor.
If the batteries were recently replaced, check the polarity. If the
wireless sensor is flashing every 20 seconds, proceed to the next
step.
There may be a temporary loss of communication due to recep-
tion loss related to interference or other location factors,
Or batteries may have been changed in the wireless seonsor and
the weather station has not been reset. The solution may be as
simple as powering down and up the weather station (remove DC
power and batteries), wait 30 seconds, and reinsert DC power and
batteries).
Allow up to one hour for the wireless sensors to stabilize due to
signal filtering. The indoor and outdoor temperature sensors
should agree within ±4℉ (±2℃) (the sensor accuacy is ±2℉ (±1℃)
Use the calibration feature to match the indoor and outdoor
temperature to a known source.
Make certain that the wireless sensor is not too close to heat
generating sources or strictures, such as buildings, pavement,
walls, or air conditioning units.
Wireless sensor does
not communicate the
weather station
Indoor and Outdoor
temperatue do not
agree
Temperatur sensor
reads too high in the
daytime
To Next Page
Loading...
