To Next Page

To Previous Page

ENGLISH

Installing the Monitor

Cable connection and organize

Before connecting the connectors, remove the back door as shown below.

1 Lift the back door in the direction of the arrow below to remove it. The back door is held in place with a

magnet.

2 Remove the cable holder screws tightened on the back of the monitor. After installing the cables, tidy

them up using the cable holders. Once the cables are tidy up, assemble it using the cable holder screws.

3 Once the back door is attached, assemble it using the screws.

CAUTION

• When the back door is attached to the monitor, the monitor meets water resistance standards. Do not use the

monitor with the back door detached, as the water resistance capability is not guaranteed without the door.

• Only fix the back door with screws when the potential equalization conductor is not connected. When the

potential equalization conductor is connected, don't fix the back door with screws (you can cover the back

door with a magnet only).

Questions and Answers:

Need help?

Do you have a question about the LG 27HQ710S-W and is the answer not in the manual?

LG 27HQ710S-W Specifications

General