PAGE 54
Troubleshooting (Continued)
SYMPTOM
Remote control doesn’t work.
Menu options can’t be
changed or selected.
No picture or sound
when any non-cable source
is selected.
Weak or no Stereo Sound
when using a stereo VCR.
Time is incorrect.
POSSIBLE SOLUTIONS
• Make sure the batteries are fresh and installed properly.
• Try unplugging your TV for a few minutes,
then plug it back in.
• Check to see if the source equipment has been turned on.
• Make sure that the connections are secure on the back of your TV and on the
source equipment.
• Check to see if all the connections are secure.
• Look in the Audio mode menu to see if all the settings are correct.
• If you are using channel 3 or 4 to view your VCR, stereo sound will not be
available.
• Make sure the time was set initially. Probably power was lost.
• Reset clock manually.
To Next Page
Loading...
