Mounting
on a table
1 Lift and tilt the
TV
into its upright position
on
a
table.
- Leave a
10
em
(4
inch) (minimum) space from
the wall for proper ventilation.
2 Connect the power cord to a wall outlet.
Lt_
CAUTION
---------.._
•
Do
not place the
TV
near or
on
sources
of
heat,
as
this may result
in
fire or other
damage.
(Depending
on
model)
Swivel
20
degrees to the left or right
and
adjust
the angle of the
TV
to suit your view.
Lt_
CAUTION
--------------
• When adjusting the angle
of
the
TV,
watch out for your fingers.
- Personal injury may occur if hands or
fingers are pinched. If the product
is
tilted too much, it may fall, causing
damage or injury.
ASSEMBLING
AND
PREPARING
29
-------
(For
32CS460, 32CS461, 42CS530,
32/37/42CS560, 32/42LS3400, 32LS341
0,
32/42LS3450, 32LS3500, 32LS351
0,
47LS4500)
Fix
the
TV
to a table to prevent from tilting
forward, damage,
and
potential injury.
Mount the
TV
on
a table,
and
then insert
and
tighten the supplied screw
on
the rear of the
stand.
A
WARNING----------.
•
To
prevent
TV
from falling over, the
TV
should
be
securely attached to the floor/
wall per installation instructions. Tipping,
shaking, or rocking the
TV
may cause injury.
I
To Next Page
Loading...
