6-3. AV NTSC adjustment
1) Connect the Video Signal Generator (Master) to AV input
terminal with AV output. At this time, when you enter the
input pattern as Model : 201(NTSC), Pattern : 33(100%
color Bar), the following video is displayed on the screen.
2) Press the ADJ key on the adjustment remote control to
enter ‘EZ-ADJUST’. Select ‘4.Adjust AV_NTSC’ and press
the right key (
G) to enter the adjustment mode.
3) When the adjustment is completed, a message saying ‘AV-
NTSC Configuration Success’ is displayed. If the
adjustment has failed, a message saying ‘AV-NTSC
Configuration Fail’ is displayed.
- 13 -
LGE Internal Use OnlyCopyright © 2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes
<Fig 6> Model : 201(NTSC), Pattern 33(100% color Bar)
To Next Page
Loading...
