26
206-4213
118 - POWER SAVINGS
Default set to 3—the power circuitry for both the embedded b-
LAN module and the GAME CONTROL/MPI port is only powered
when the TV is turned ON. When the TV is in Standby Mode, the
embedded b-LAN and the GAME CONTROL/MPI port are not
powered.
Note that the TV must be turned ON in order to communicate with
the embedded b-LAN module for conguration and control when
POWER SAVINGS is set to 3. If POWER SAVINGS is set to 1,
the b-LAN module is always powered.
Similarly, if MPI communication is required for external MPI
control, POWER SAVINGS should be set to 1 so that the GAME
CONTROL/MPI port circuitry is always powered.
LT670H TVs only: For specific applications, the RS-232 (DB9)
port may be used to provide +12v/1A external power (for example,
to an external MPI control device). In this case, Installer Menu
item 118 POWER SAVINGS must be set to 9—both the b-LAN
module and the GAME CONTROL/MPI port circuitry are always
powered, and the external power is provided on pin 9 of the
RS-232 port.
Note: See Reference section, “b-LAN Setup & Overview,” for
further information.
Caution: POWER SAVINGS should NEVER be set to 7.
This setting is intended for factory use only.
119 - DATA CHANNEL
Set to 0 (default) to disable. Set to the RF channel number of the
data channel for Pro:Centric application (item 098 PRO:CENTRIC
must be set appropriately) and/or TV E-Z Installation (splash
screen, configuration, or firmware) data.
Note: Pro:Centric updates are downloaded from the Pro:Centric
server to the TV when the TV is turned OFF. While Pro:Centric
updates are in progress, it is not possible to turn ON the TV.
121 - P:C RF WAKE HR
Set the hour from 0 to 23 for Wake On RF. This item uses the 24-
hour clock format. The value “128” is displayed as “OFF.” Directly
entering 128 turns the Wake On RF feature OFF.
Note: This item is not available in the Installer Menu when item
119 DATA CHANNEL is set to 0.
122 - P:C RF WAKE MN
Set the minute from 0 to 59 for Wake On RF.
Note: This item is not available in the Installer Menu when item
119 DATA CHANNEL is set to 0 or when item 121 P:C RF WAKE
HR is set to 128/OFF.
Installer Menu (Cont.)
To Next Page
Loading...
