LG 37LG50 Series - External Equipment Setup; HD Receiver Setup

11
EXTERNAL EQUIPMENT SETUP
HD RECEIVER SETUP
■
This TV can receive Digital RF/Cable signals without an external digital set-top box. However, if you do receive
Digital signals from a digital set-top box or other digital external device, refer to the diagram as shown below.
COMPONENT IN
12
VIDEO AUDIO
RGB IN (PC)
OPTICAL
DIGITAL
AUDIO OUT
RS-232C IN
(CONTROL & SERVICE)
AUDIO
(RGB/DVI)
HDMI/DVI IN
2
1(DVI)
Connecting with a component cable
Connect the video outputs
(
Y, PB, PR
)
of the digital
set top box to the
CCOOMMPPOONNEENNTT IINN11 VVIIDDEEOO
jacks
on the TV.
Connect the audio output of the digital set-top box to
the
CCOOMMPPOONNEENNTT IINN11 AAUUDDIIOO
jacks on the TV.
Turn on the digital set-top box.
(
Refer to the owner’s manual for the digital set-top
box.
)
Select Component1 input source using the
IINNPPUUTT
button on the remote control.
If connected to
CCOOMMPPOO NNEE NNTT II NN22
, select
Component2 input source.
2
3
4
1
Signal
480i/576i
480p/576p
720p/1080i
108 0 p
(24Hz/30Hz/50Hz/60Hz)
Component1/2
Yes
Yes
Yes
Yes
HDMI1/DVI, HDMI2
No
Yes
Yes
Yes
1 2
■
To avoid damaging any equipment, never plug in any power cords until you have finished connecting all equipment.
EXTERNAL EQUIPMENT SETUP