ENGLISH
32
EXTERNAL CONTROL DEVICE SETUP
EXTERNAL CONTROL DEVICE SETUP
RS-232C Setup
Connect the RS-232C (serial port) input jack to an
external control device (such as a computer or an A/
V control system) to control the product’s functions
externally.
Connect the serial port of the control device to the RS-
232C jack on the product back panel.
RS-232C IN
(CONTROL & SERVICE)
RS-232C on this unit is intended to be used with
third party RS-232C control hardware and software.
The instructions below are provided to help with
programming software or to test functionality using
telenet software. RS-232C connection cables are
not supplied with the product..
NOTE
Type of Connector;
D-Sub 9-Pin Male
1 5
6 9
RS-232C IN
(CONTROL & SERVICE)
No. Pin name
1 No connection
2 RXD (Receive data)
3 TXD (Transmit data)
4 DTR (DTE side ready)
5 GND
6 DSR (DCE side ready)
7 RTS (Ready to send)
8 CTS (Clear to send)
9 No Connection
To Next Page
Loading...
