July 2009 LCD DV 42LH40
7
Safety and Handling Regulations
1. Approximately 20 minute pre-run time is required before any adjustments are performed.
2. Refer to the Voltage Sticker on the Switch Mode Power Supply silk screening. (+/- ½ volt).
3. Be cautious of electric shock from the Backlight section, it uses high voltage AC. Check that
the Power Supply and Drive Circuits are completely discharged because of residual current
stored before Circuit Board removal.
4. C-MOS circuits are sensitive to static electricity.
Use caution when dealing with these IC and circuits.
5. Exercise care when making voltage and waveform checks to prevent costly short circuits
from damaging the unit.
6. Be cautious of lost screws and other metal objects to prevent a possible short in the
circuitry.
1. Check the appearance of the Replacement Panel and Circuit Boards for both physical damage
and part number accuracy.
2. Check the model label. Verify model names and board model matches.
3. Check details of defective condition and history. Example: Oscillator failure dead set, etc…
Checking Points to be Considered
SECTION 1: LCD DIRECT VIEW OVERVIEW
SECTION 1: LCD DIRECT VIEW OVERVIEW
To Next Page
Loading...
