9
ASSEMBLY AND PREPARATION
ENGLISH
Connecting IR & Light Sensor
When you connect the cable to the product,
the feature for receiving remote control signals
is activated. The IR & light sensor is magnetic.
Attach it to the front edge of the product for use.
[Front]
CAUTION
CAUTION
Portrait Layout
When installing in a portrait layout, rotate the
monitor counterclockwise 90 degrees (when
facing the screen).
(This is not available for all models.)
The Kensington security system connector is
located at the back of the monitor. For more
information on installation and use of this
system, refer to the manual provided with the
Kensington security system or visit http://www.
kensington.com.
Connect the Kensington security system cable
between the monitor and a table.
Using Kensington Lock
• The Kensington security system is optional.
You can obtain additional accessories from
most electronics retail stores.
NOTE
• Please turn off the power before removing
the cable. Connecting or removing the
speaker cable while turned on may result in
no sound.
NOTE
NOTE
• The signal strength of the IR and Light
sensor will decrease if the sensor is not
placed in front of the product.
To Next Page
Loading...
Need help?
General
