PREPARATION
9
PREPARATION
ACCESSORIES
Ensure that the following accessories are included with your TV. If an accessory is missing, please contact the
dealer where you purchased the TV.
The accessories included may differ from the images below.
Bolts for stand assembly
(Refer to P.16)
x 4
Cable Holder
(Refer to P.21)
Protection Cover
(Refer to P.17, 19)
Batteries
(Some models)
RF Adapter
(Some models)
You must connect it to the antenna
wire after fixing in Antenna Input.
This adapter is only supplied in
AArrggeennttiinnaa
.
x 2
or
M4x28
(Except 60PK550R)
x 3
M5x14
CD Manual
4422//5500PPJJ225500RR,, 4422//5500PPJJ226600RR,, 4422//5500PPJJ335500RR,, 5500//6600PPKK555500RR
* Wipe spots on the exterior only with
the polishing cloth.
* Do not wipe roughly when removing
stain. Excessive pressure may cause
scratch or discoloration.
Polishing Cloth
(Not included with all models.)
Ferrite Core
(Black)
(This feature is not
available for all
models.)
close to the wall plug.
Ferrite core can be used to
reduce the electromagnetic waves
that may interfere with the TV.
Install the Ferrite core on the
power cable close to the wall
plug.
The ferrite core can be used to reduce the electromag-
netic waves in the PC Audio cable.
Wind the PC Audio cable on the ferrite core twice, and
then plug the cables into the TV as shown in the fol-
lowing picture.
Place the ferrite core close to AUDIO IN(RGB/DVI) jack
on the display.
Place the ferrite core close to
AUDIO IN(RGB/DVI) jack on the display.
Ferrite Core
(Gray)
(This feature is not
available for all
models.)
Ferrite Core
(Gray)
(This feature is
available only
42PJ*** models.)
Ferrite core can be used to reduce
RF noise when connecting the RF
cable.
The closer the location of the fer-
rite core to the “ANTENNA IN”, the
better it is.
TV
Wal l
Tie Band
To Next Page
Loading...
Need help?
General
