7
Screen, Frame, Cabinet, and Stand
To remove dust or light dirt, wipe the surface with a
dry, clean, and soft cloth.
To remove major dirt, wipe the surface with a soft
cloth dampened in clean water or a diluted mild
detergent. Then wipe immediately with a dry cloth.
CAUTION
Do not push, rub, or hit the surface with your
fingernail or a sharp object, as this may result in
scratches on the screen and image distortions.
Do not use any chemicals, such as waxes,
benzene, alcohol, thinners, insecticides, air
fresheners or lubricants, as these may damage
the screen’s finish and cause discoloration.
Do not spray liquid onto the surface. If water
enters the TV, it may result in fire, electric shock,
or malfunction.
Power Cord
Remove the accumulated dust or dirt on the power
cord regularly.
Lifting and Moving the TV
When moving or lifting the TV, read the following to
prevent the TV from being scratched or damaged
and for safe transportation regardless of its type and
size.
It is recommended to move the TV in the box or
packing material that the TV originally came in.
Before moving or lifting the TV, disconnect the
power cord and all cables.
When holding the TV, the screen
should face away from you to
avoid damage.
Hold the top and bottom of the TV frame firmly.
Make sure not to hold the transparent part,
speaker, or speaker grille area.
Use at least two people to move
a large TV.
When transporting the TV by
hand, hold the TV as shown in
the following illustration.
When transporting the TV, do not expose the TV
to jolts or excessive vibration.
When transporting the TV, keep the TV upright;
never turn the TV on its side or tilt towards the
left or right.
When handling the TV, be careful not to
damage the protruding joystick button.
CAUTION
Avoid touching the screen at all times, as this
may result in damage to the screen.
Do not place the product on the floor with its
front facing down without padding. Failure to do
so may result in damage to the screen.
Do not move the TV by holding the cable holder
and cable management, as the cable holders
may break, and injuries and damage to the TV
may occur.
Using the Joystick Button
(Image shown may differ from your TV.)
You can operate the TV by pressing the button or
moving the joystick left, right, up, or down.
Joystick Button
Basic functions
When the TV is turned off, place
your finger on the joystick button,
press it once and release it.
Power On
When the TV is turned on, place
your finger on the joystick button,
press it once for a few seconds, and
release it. All running apps will close
and any recording in progress will
stop.
Power Off
Place your finger on the joystick
button and move it left or right to
adjust the volume level.
Volume Control
Place your finger on the joystick
button and move it up or down to
adjust the channel.
Channels
Control
To Next Page
Loading...
Need help?
General
