LG 43SL5E - Page 94

ENGLISH
44
01. Power (Command: k a)
Controls the power on/off status of the monitor.
Transmission
[k][a][ ][Set ID][ ][Data][Cr]
Data 00: Off
01: On
Acknowledgment
[a][ ][Set ID][ ][OK/NG][Data][x]
* The Acknowledgment signal is returned properly only when the monitor
is fully powered on.
* There may be a delay between the Transmission and Acknowledgment
signals.
* This feature may not be available for all models.
02. Select Input (Command: x b)
Selects an input signal.
Transmission
[x][b][ ][Set ID][ ][Data][Cr]
Data 20: AV
40: Component
60: RGB
70: DVI-D (PC)
80: DVI-D (DTV)
90: HDMI (HDMI1) (DTV)
A0: HDMI (HDMI1) (PC)
91: HDMI2/OPS (DTV)
A1: HDMI2/OPS (PC)
C0: DISPLAYPORT (DTV)
D0: DISPLAYPORT (PC)
Acknowledgment
[b][ ][Set ID][ ][OK/NG][Data][x]
* Some input signals may not be available for all models.
03. Aspect Ratio (Command: k c)
Adjusts the aspect ratio of your monitor.
Transmission
[k][c][ ][Set ID][ ][Data][Cr]
Data 02: Full Screen
06: Original
Acknowledgment
[c][ ][Set ID][ ][OK/NG][Data][x]
* The aspect ratio may differ depending on the model's input
configuration.
04. Power Saving (Command: j q)
Configures the Power Saving mode.
Transmission
[j][q][ ][Set ID][ ][Data][Cr]
Data 00: Off
01: Minimum
02: Medium
03: Maximum
05: Screen Off
Acknowledgment
[q][ ][Set ID][ ][OK/NG][Data][x]
* This feature may not be available for all models.
05. Picture Mode (Command: d x)
Selects a picture mode.
Transmission
[d][x][ ][Set ID][ ][Data][Cr]
Data 00: Mall/QSR
01: General
02: Gov./Corp.
03: Transportation
04: Education
05: Expert (Expert 1)
06: Expert (Expert 2)
08: APS
11: Calibration
Acknowledgment
[x][ ][Set ID][ ][OK/NG][Data][x]
* Some picture modes may not be available for all models.
06. Contrast (Command: k g)
Adjusts the screen contrast.
Transmission
[k][g][ ][Set ID][ ][Data][Cr]
Data 00-64: Contrast 0-100
Acknowledgment
[g][ ][Set ID][ ][OK/NG][Data][x]