47
19. No Signal Power Off (Command: f g)
Sets the No Signal Power Off function.
Transmission
[f][g][ ][Set ID][ ][Data][Cr]
Data 00: Off (Not turned off after 15 minutes)
01: On (Turned off after 15 minutes)
Acknowledgment
[g][ ][Set ID][ ][OK/NG][Data][x]
20. No IR Power Off (Command: m n)
Activates Auto Power Off when there is no IR signal.
Transmission
[m][n][ ][Set ID][ ][Data][Cr]
Data 00: Off (Not turned off after 2/4/6/8 hours)
01: 2 hours (Turned off after 2 hours)
02: 4 hours (Turned off after 4 hours)
03: 6 hours (Turned off after 6 hours)
04: 8 hours (Turned off after 8 hours)
Acknowledgment
[n][ ][Set ID][ ][OK/NG][Data][x]
21. Language (Command: f i)
Sets the OSD language.
Transmission
[f][i][ ][Set ID][ ][Data][Cr]
Data 00: Czech
01: Danish
02: German
03: English
04: Spanish (Europe)
05: Greek
06: French
07: Italian
08: Dutch
09: Norwegian
0A: Portuguese
0B: Portuguese (Brazil)
0C: Russian
0D: Finnish
0E: Swedish
0F: Korean
10: Chinese (Cantonese)
11: Japanese
12: Chinese (Mandarin)
13: Arabic
Acknowledgment
[i][ ][Set ID][ ][OK/NG][Data][x]
* Some languages may not be available for all models.
22. Initial Value Settings (Command: f k)
Executes Reset.
(Initialize Screen can only be executed in RGB input mode.)
Transmission
[f][k][ ][Set ID][ ][Data][Cr]
Data 00: Picture Reset
01: Initialize Screen
02: Reset to Initial Settings
Acknowledgment
[k][ ][Set ID][ ][OK/NG][Data][x]
* This feature may not be available for all models.
23. Current Temperature (Command: d n)
Checks the current temperature of the product.
Transmission
[d][n][ ][Set ID][ ][Data][Cr]
Data FF: Status Check
Acknowledgment
[n][ ][Set ID][ ][OK/NG][Data][x]
* The temperature is displayed in hexadecimal.
24. Key (Command: m c)
Sends a key code for the IR remote control.
Transmission
[m][c][ ][Set ID][ ][Data][Cr]
Data IR_KEY_CODE
Acknowledgment
[c][ ][Set ID][ ][OK/NG][Data][x]
* For key codes, see IR Codes.
* Some key codes may not be supported depending on the model.
To Next Page
Loading...
