49
33. White Balance Blue Offset (Command: s z)
Adjusts the blue offset value for white balance.
Transmission
[s][z][ ][Set ID][ ][Data][Cr]
Data 00-7F: Blue Offset 0-127
FF: Checks blue offset value
Acknowledgment
[z][ ][Set ID][ ][OK/NG][Data][x]
34. Backlight (Command: m g)
Adjusts the backlight brightness.
Transmission
[m][g][ ][Set ID][ ][Data][Cr]
Data 00-64: Backlight 0-100
Acknowledgment
[g][ ][set ID][][OK/NG][Data][x]
35. Screen Off (Command: k d)
Turns off/off the screen.
Transmission
[k][d][ ][Set ID][ ][Data][Cr]
Data 00: Screen On
01: Screen Off
Acknowledgment
[d][ ][Set ID][ ][OK/NG][Data][x]
* This feature may not be available for all models.
36. Tile Mode (Command: d d)
Sets a tile mode and values for the tile rows and columns.
Transmission
[d][d][ ][Set ID][ ][Data][Cr]
Data 00-FF: The first byte - tile column
The second byte - tile row
* 00, 01, 10, and 11 mean that the tile mode is off.
* The maximum value may differ depending on the model.
Acknowledgment
[d][ ][Set ID][ ][OK/NG][Data][x]
* This feature may not be available for all models.
37. Tile Mode Check (Command: d z)
Checks the tile mode.
Transmission
[d][z][ ][Set ID][ ][Data][Cr]
Data FF: Check Tile Mode
Acknowledgment
[z][ ][Set ID][ ][OK/NG][Data1][Data2][Data3][x]
Data 1 00: Tile Mode off
01: Tile Mode on
Data 2 00-0F: Tile column
Data 3 00-0F: Tile row
* This feature may not be available for all models.
38. Tile ID (Command: d i)
Sets the tile ID value of the product.
Transmission
[d][i][ ][Set ID][ ][Data][Cr]
Data 01-E1: Tile ID 1-225
FF: Checks the Tile ID
* The data value cannot exceed the value of row x column.
Acknowledgment
[i][ ][Set ID][ ][OK/NG][Data][x]
* If you enter a value that exceeds the value of row x column for the Data
parameter (except for 0xFF), Ack becomes NG.
* This feature may not be available for all models.
To Next Page
Loading...
