LG 49LW540S - Page 29

• Commands may work differently depending upon
model and signal.
01. Power (Command: k a)
• To control Power *On or Off of the set.
Transmission[k][a][ ][Set ID][ ][Data][Cr]
Data 00 : Power Off
01 : *Power On
Ack [a][ ][Set ID][ ][OK/NG][Data][x]
• To Show TV is Power On or *Off
Transmission [k][a][ ][Set ID][ ][FF][Cr]
Ack [a][ ][Set ID][ ][OK][Data][x]
* Similarly, if other functions transmit ‘FF’ data based
on this format, Acknowledgement feedback presents
status about each function.
02. Aspect Ratio (Command: k c) (Main Picture Size)
• To adjust the screen format. (Main picture format) You
can also adjust the screen format using the Aspect Ratio
in the Q.MENU or PICTURE menu.
Transmission [k][c][ ][Set ID][ ][Data][Cr]
Data 01 : Normal screen (4:3)
02 : Wide screen(16:9)
04 : Zoom
05 : Zoom 2
(Latin America except
Colombia Only)
06 : Set by Program/
Original
07 : 14:9
(Europe, Colombia,
Mid-East, Asia except
South Korea and Japan)
09 : * Just Scan
0B : Full Wide
(Europe, Colombia,
Mid-East, Asia except
South Korea and Japan)
10 to 1F : Cinema Zoom
1 to 16
Ack [c][ ][Set ID][ ][OK/NG][Data][x]
• Using the PC input, you select either 16:9 or 4:3 screen
aspect ratio.
• In DTV/HDMI/Component mode (high-definition), Just
Scan is available.
• Full wide mode may work differently based on model
and is supported for DTV fully, and ATV, AV partially.
03. Screen Mute (Command: k d)
• To select screen mute on/off.
Transmission [k][d][ ][Set ID][ ][Data][Cr]
Data 00 : Screen mute off (Picture on)
Video mute off
01 : Screen mute on (Picture off)
10 : Video mute on
Ack [d][ ][Set ID][ ][OK/NG][Data][x]
* In case of video mute on only, TV will display On Screen
Display(OSD). But, in case of Screen mute on, TV will
not display OSD.
04. Volume Mute (Command: k e)
• To control volume mute on/off.
You can also adjust mute using the MUTE button on
remote control.
Transmission [k][e][ ][Set ID][ ][Data][Cr]
Data 00 : Volume mute on (Volume off)
01 : Volume mute off (Volume on)
Ack [e][ ][Set ID][ ][OK/NG][Data][x]
05. Volume Control (Command: k f)
• To adjust volume.
You can also adjust volume with the volume buttons on
remote control.
Transmission [k][f][ ][Set ID][ ][Data][Cr]
Data Min : 00 to Max : 64
Ack [f][ ][Set ID][ ][OK/NG][Data][x]
06. Contrast (Command: k g)
• To adjust screen contrast.
You can also adjust contrast in the PICTURE menu.
Transmission [k][g][ ][Set ID][ ][Data][Cr]
Data Min : 00 to Max : 64
Ack [g][ ][Set ID][ ][OK/NG][Data][x]
21
ENGLISH