LG 55EJ5E - Page 100

ENGLISH
62
18. No Signal Power Off (15 Min) (Command: f g)
Sets the monitor to enter Automatic Standby mode if there is
no signal for 15 minutes.
Transmission
[f][g][ ][Set ID][ ][Data][Cr]
Data 00: Off
01: On
Acknowledgment
[g][ ][Set ID][ ][OK/NG][Data][x]
19. No IR Power Off (Command: m n)
Activates Auto Power Off when there is no IR signal for 4 hours.
Transmission
[m][n][ ][Set ID][ ][Data][Cr]
Data 00: Off
01: On
Acknowledgment
[n][ ][Set ID][ ][OK/NG][Data][x]
20. Language (Command: f i)
Sets the OSD language.
Transmission
[f][i][ ][Set ID][ ][Data][Cr]
Data 00: Czech
01: Danish
02: German
03: English
04: Spanish (Europe)
05: Greek
06: French
07: Italian
08: Dutch
09: Norwegian
0A: Portuguese
0B: Portuguese (Brazil)
0C: Russian
0D: Finnish
0E: Swedish
0F: Korean
10: Chinese (Mandarin)
11: Japanese
12: Chinese (Cantonese)
13: Arabic
Acknowledgment
[i][ ][Set ID][ ][OK/NG][Data][x]
* Some languages may not be available with certain models.
21. Initial Settings (Command: f k)
Executes Reset.
Initialize Screen can only be executed in RGB input mode.
Transmission
[f][k][ ][Set ID][ ][Data][Cr]
Data 00: Picture Reset
01: Initialize Screen
02: Reset to Initial Settings
Acknowledgment
[k][ ][Set ID][ ][OK/NG][Data][x]
* This feature may not be supported on some models.
22. Current Temperature (Command: d n)
Checks the current temperature of the product.
Transmission
[d][n][ ][Set ID][ ][Data][Cr]
Data FF: Check status
Acknowledgment
[n][ ][Set ID][ ][OK/NG][Data][x]
* The temperature is displayed in hexadecimal.
23. Key (Command: m c)
Sends a key code for the IR remote control.
Transmission
[m][c][ ][Set ID][ ][Data][Cr]
Data IR_KEY_CODE
Acknowledgment
[c][ ][Set ID][ ][OK/NG][Data][x]
For key codes, see IR Codes.
* Some key codes may not be supported on some models.