LG 55EJ5E - Page 107

ENGLISH
69
51. Network Settings (Command: s n, 80 or 81 or
82)
Configures network and DNS settings.
Transmission
[s][n][ ][Set ID][ ][Data1][ ][Data2][ ]
[Data3][ ][Data4][ ][Data5][Cr]
Data1 80: Configures/views the temporary IP mode
(Auto/Manual), subnet mask, and gateway.
81: Configures/views the temporary DNS address.
82: Saves temporary settings and views
information about the current network.
* If Data1 is 80,
Data 2 00: Auto
01: Manual
FF: Views the temporary IP mode (Auto/Manual),
subnet mask, and gateway.
* If Data2 is 01 (Manual),
Data 3 Manual IP address
Data 4 Subnet mask address
Data 5 Gateway address
* If Data1 is 81,
Data 2 DNS address
FF: Displays the temporary DNS address.
* If Data1 is 82,
Data 2 80: Applies the temporarily saved IP mode (Auto/
Manual), subnet mask and gateway.
81: Applies the temporary DNS address
FF: Information on the current network (IP, subnet
gateway and DNS)
* An example of settings,
1. Auto: sn 01 80 00
2. Manual: sn 01 80 01 010177223241 255255254000
010177222001 (IP: 10.177.223.241, subnet:
255.255.254.0, gateway: 10.177.222.1)
3. Network read: sn 01 80 ff
4. DNS settings: sn 01 81 156147035018 (DNS:
156.147.35.18)
5. Applying the settings: sn 01 82 80 (applies the saved IP
mode (auto/manual), subnet mask, and
gateway), sn 01 82 81 (applies the
saved DSN)
* Each IP address contains 12 decimal digits.
Acknowledgment
[n][ ][Set ID][ ][OK/NG][Data1][Data][x]
* This feature is available only for wired networks.
* This feature may not be supported on some models.
52. Auto Configuration (Command: j u)
Automatically corrects the position and shaking of the picture.
(Works only in RGB-PC input mode.)
Transmission
[j][u][ ][Set ID][ ][Data][Cr]
Data 01: Execution
Acknowledgment
[u][ ][Set ID][ ][OK/NG][Data][x]
* This feature may not be supported on some models.
53. H Position (Command: f q)
Adjusts the horizontal position of the screen.
* The operational range varies depending on the RGB input
resolution.
(Works only in RGB-PC input mode.)
Transmission
[f][q][ ][Set ID][ ][Data][Cr]
Data 00-64: Min -50 (Left) to Max 50 (Right)
Acknowledgment
[q][ ][Set ID][ ][OK/NG][Data][x]
* This feature may not be supported on some models.
54. V Position (Command: f r)
Adjusts the vertical position of the screen.
* The operational range varies depending on the RGB input
resolution.
(Works only in RGB-PC input mode.)
Transmission
[f][r][ ][Set ID][ ][Data][Cr]
Data 00-64: Min -50 (Down) to Max 50 (Up)
Acknowledgment
[r][ ][Set ID][ ][OK/NG][Data][x]
* This feature may not be supported on some models.