LG 55EJ5E - Page 97

ENGLISH
59
01. Power (Command: k a)
Controls the power on/off status of the monitor.
Transmission
[k][a][ ][Set ID][ ][Data][Cr]
Data 00: Off
01: On
02: Reboot
Acknowledgment
[a][ ][Set ID][ ][OK/NG][Data][x]
* The Acknowledgment signal is returned properly only when
the monitor is fully powered on.
* There may be a delay between the Transmission and
Acknowledgment signals.
* This feature may not be supported on some models.
02. Select Input (Command: x b)
Selects an input signal.
Transmission
[x][b][ ][Set ID][ ][Data][Cr]
Data 20: AV
40: COMPONENT
60: RGB
70: DVI-D (PC)
80: DVI-D (DTV)
90: HDMI1 (DTV)
A0: HDMI1 (PC)
91: HDMI2/OPS (DTV)
A1: HDMI2/OPS (PC)
92: OPS/HDMI3/DVI-D (DTV)
A2: OPS/HDMI3/DVI-D (PC)
95: OPS/DVI-D (DTV)
A5: OPS/DVI-D (PC)
96: HDMI3/DVI-D (DTV)
A6: HDMI3/DVI-D (PC)
97: HDMI3/HDMI2/DVI-D (DTV)
A7: HDMI3/HDMI2/DVI-D (PC)
98: OPS (DTV)
A8: OPS (PC)
C0: DISPLAYPORT (DTV)
D0: DISPLAYPORT (PC)
E0: SuperSign webOS Player
E1: Others
E2: Multi Screen
Acknowledgment
[b][ ][Set ID][ ][OK/NG][Data][x]
* Some input signals may not be available with certain models.
* If it is not distributed from SuperSign W, WebOS Player
returns NG.
03. Aspect Ratio (Command: k c)
Adjusts the aspect ratio of your monitor.
Transmission
[k][c][ ][Set ID][ ][Data][Cr]
Data 02: Full Wide
06: Original
Acknowledgment
[c][ ][Set ID][ ][OK/NG][Data][x]
* The aspect ratio may differ depending on the model's input
configuration.
04. Brightness Control (Command: j q)
Sets the brightness of your monitor.
Transmission
[j][q][ ][Set ID][ ][Data][Cr]
Data 00: Off
01: Minimum
02: Medium
03: Maximum
04: Automatic
05: Screen Off
Acknowledgment
[q][ ][Set ID][ ][OK/NG][Data][x]
* This feature may not be supported on some models.
05. Picture Mode (Command: d x)
Selects a picture mode.
Transmission
[d][x][ ][Set ID][ ][Data][Cr]
Data 00: Mall/QSR
01: General
02: Gov./Corp.
03: Transportation
04: Education
05: Expert 1
06: Expert 2
08: APS
09: Photo
11: Calibration
Acknowledgment
[x][ ][Set ID][ ][OK/NG][Data][x]
* Depending on the model, some picture modes may not be
supported.