ENGLISH
68
44. Remote Controller Key Lock (Command: t p)
Configures the settings of the product's remote control key.
Transmission
(t)(p)( )([Set ID])( )(Data)(Cr)
Data 00: All keys lock off
01: Locks on all keys except Power key
02: Locks on all keys
Acknowledgment
(p)( )([Set ID])( )(OK/NG)(Data)(x)
* When the monitor is turned off, the power key works even in
the locks on all of the keys (02) mode.
45. [Local Key Lock] (Command: t o)
Configures the local key operation settings of the product.
Transmission
(t)(o)( )([Set ID])( )(Data)(Cr)
Data 00: All keys lock off
01: Locks on all keys except Power key
02: Locks on all keys
Acknowledgment
(o)( )([Set ID])( )(OK/NG)(Data)(x)
* When the monitor is turned off, the power key works even in
the locks on all of the keys (02) mode.
* This feature may not be supported on some models.
46. Check [Status] (Command: s v)
Checks the current signal of the product.
Transmission
(s)(v)( )([Set ID])( )(Data)( )(FF)(Cr)
Data 02: Checks whether there is a signal
03: The monitor is currently in [PM Mode]
07: Checks whether the Top, Bottom and Main
temperature sensors are functioning normally.
08: The temperature of each temperature sensor
when the monitor set was last powered off.
09: Fan speed
10: RGB Sensing OK/NG (screen fault detection)
Acknowledgment
(v)( )([Set ID])( )(OK/NG)(Data)(Data1)(x)
Data 02 (when a signal is found)
Data1 00: No signal
01: Signal present
Data 03 (when the monitor is currently in PM mode)
Data1 00: [Screen On] is activated.
01: [Screen Off] is activated.
02: [Screen Off Always] is activated.
03: [Sustain Aspect Ratio] is activated.
04: [Screen Off & Backlight] is activated.
Data 07 (when checking whether the Top, Bottom and
Main temperature sensors are working properly)
Data1 00: All temperature sensors faulty
01: Top normal, Bottom faulty, Main faulty
02: Top faulty, Bottom normal, Main faulty
03: Top normal, Bottom normal, Main faulty
04: Top faulty, Bottom faulty, Main normal
05: Top normal, Bottom faulty, Main normal
06: Top faulty, Bottom normal, Main normal
07: All temperature sensors are normal
Data 10 (when executing [Screen Fault Detection])
Data1 00: [Screen Fault Detection] result NG
07: [Screen Fault Detection] result OK
* When screen Fault Detection is set to Off or not supported,
execution results are rendered "NG."
To Next Page
Loading...
