LG 65EW960H - USB Configuration

24
206-4307
EZ-Manager Wizard (Cont.)
(Continued from previous page)
If you opt to initiate a real-time download in the last step, the EZ-Manager Wizard will proceed with
the Pro:Centric application and/or E-Z Installation data downloads (see Processing the Pro:Centric
Conguration screen example on page 21). When the Pro:Centric conguration is complete, an
EZ-Manager Conguration Complete screen (see example on page 21) is displayed, and after
10 seconds, the wizard exits, and the TV turns OFF.
Note: With the EZ-Manager Conguration Complete screen on display, you can also manually
turn off or reboot the TV. If desired, select TURN OFF or REBOOT, respectively, and then press the
Wheel (OK) button on the Installer Remote.
USB Conguration
TV Manager / USB download options enable you to download conguration or software les
individually from a USB memory device to the TV. You can also use the Ez Download utility available
from the menu to select one of each type of le to be downloaded at one time using one process.
Each of the USB download functions requires that you have the appropriate le(s) loaded on a USB
memory device. If you wish to perform a software update, the software update le must be stored in
a folder named “LG_DTV” in the root directory of the USB memory device. Clone/Conguration (.tlx)
les should simply be stored in the root directory of the USB device.
The procedure below assumes the desired le(s) is/are already loaded onto the USB device. For
further information on the TV Manager / USB download options and le requirements, and/or for
information on creating Clone/Conguration (.tlx) les, refer to the appropriate section(s) in this
document.
Before You Begin
• If you intend to use the Zoning feature(s) on this TV, make sure to assign the appropriate TV
Zone # and/or Wi-Fi Zone # in the EZ-Manager’s Zones, Label, and Room Number screen
BEFORE continuing with USB Conguration. See “TV Conguration Options” on page 18 for
further information.
• Ensure the USB device to be used has been formatted with FAT format.
• When creating les to be downloaded, avoid using special characters (?, &, @, etc.) in lenames.
• Refer to “Ez Download Utility” on pages 26 to 29 for further information on the Ez Download utility.
• Refer to “Custom Master TV Setup” on pages 41 to 43 for information on creating a Clone (.tlx)
file, and/or refer to “Creating an FTG Conguration File” on pages 50 to 51 for information on
creating an FTG Conguration (.tlx) le for FTG Mode conguration.
• See Reference section, “Updating TV/PTC Software using a USB Memory Device,” for further
information on software updates.
USB Conguration via EZ-Manager Wizard
With either the TV Conguration Options or the Zones, Label, and Room Number screen on display,
proceed as follows to congure the TV using the USB memory device.
1. Insert the USB memory device with the appropriate le(s) into either of the TV’s USB ports.
(Continued on next page)