- 13 -
11)Adjust SUB-Brightness command to 0.4
±
0.1FL of
the raster luminance.
12) Display color 15,0 full white pattern at mode 4.
13) DRIVE ADJ command.
14)Set B-DRIVE to 90:HEX(5A) at DRIVE of the
alignment program.
15)Adjust R-DRIVE and G-DRIVE command to white
balance x=0.283 ± 0.003 and y=0.298 ± 0.003 on
the White Balance Meter with PC arrow keys.
16) Display color 15,0 box pattern (70x70mm) at mode 4.
17)Adjust SUB-CONTRAST command to 47±1FL of
the raster luminance.
18) Display color 15,0 full white patten at Mode 4.
19) COLOR ADJ. → LUMINANCE → ABL command.
20) Adjust ABL to 32 ± 1FL of the luminance.
21) Exit from the program.
5. Input EDID Data.
1) Display color 15,0 cross hatch pattern at Mode 4.
2) EEPROM → Write EDID command and confirm
“EDID Write OK!!” message of monitor.
3) Exit from the alignment program.
4) Power switch OFF/ON for EDID data save.
6. Adjustment for Focus.
1) Display H character in full screen at Mode 4.
2) Adjust two Focus control on the FBT that focus
should be the best condition.
To Next Page
Loading...
Need help?
General
