LG AC18BH.NSK - Page 17

17
ENGLISH
FRANÇAIS ESPAÑOL
Auto Operation (Artificial
Intelligence)
Cooling Only Model
This mode automatically sets the fan
speed and temperature depending on the
room temperature.
1
Turn the appliance on.
2
Press Mode button repeatedly to select
the Auto Operation.
•
is displayed on the display screen.
3
Press or button to select
the desired operation code if the
temperature is higher or lower than the
desired temperature.
Code Description
2 Cold
1 A little cold
0 Maintain room temperature
-1 A little hot
-2 Hot
NOTE
• In this mode, you cannot adjust the fan
speed, but you can set the air deflector to
rotate automatically.
Auto Changeover Mode
Cooling & Heating Model
This mode changes the mode
automatically to maintain the set
temperature at ±2 °C
1
Turn the appliance on.
2
Press Mode button repeatedly to select
the Auto Changeover Mode.
•
is displayed on the display screen.
3
Press or button to set the desired
temperature.
4
Press Fan Speed button to adjust the
fan speed.
Dehumidification Mode
This mode removes excess moisture from
a highly humid environment or during the
rainy season, in order to prevent mildew
from setting in. This mode adjusts the
room temperature and the fan speed
automatically to maintain the optimal level
of humidity.
1
Turn the appliance on.
2
Press Mode button repeatedly to select
the Dehumidification Mode.
•
is displayed on the display screen.
NOTE
• In this mode you cannot adjust the room
temperature, it is adjusted automatically.
• The room temperature is not displayed
on the display screen.
• In the dehumidification mode,
compressor and indoor fan may not
operate when the room temperature is
below 24 °C