n Installation
Installation is to be performed by qualified personnel
who are familiar with local codes and regulations.
- There is risk of fire, electric shock, explosion, or injury.
Always install a dedicated circuit and breaker.
- Improper wiring or installation may cause fire or electric shock.
For re-installation of the installed product, always
contact a dealer or an Authorized Service Center.
- There is risk of fire, electric shock, explosion, or injury.
Do not install, remove, or re-install the unit by your-
self (customer).
- There is risk of fire, electric shock, explosion, or injury.
Prepare for strong wind or earthquake and install the
unit at the specified place.
- Improper installation may cause the unit to topple and result in
injury.
When installing and moving the Product to another
site, do not charge it with a different refrigerant from
the refrigerant specified on the unit.
- If a different refrigerant or air is mixed with the original refriger-
ant, the refrigerant cycle may malfunction and the unit may be
damaged.
Securely install the cover of control box and the
panel.
- If the cover and panel are not installed securely, dust or water
may enter the outdoor unit and fire or electric shock may result.
If the Product is installed in a small room, measures
must be taken to prevent the refrigerant concentra-
tion from exceeding the safety limit when the refrig-
erant leaks.
- Consult the dealer regarding the appropriate measures to pre-
vent the safety limit from being exceeded. Should the refriger-
ant leak and cause the safety limit to be exceeded, hazards
due to lack of oxygen in the room could result.
Use the correctly rated breaker or fuse.
- There is risk of fire or electric shock.
Have all electric work done by a licensed electrician
according to regulations and the instructions given in
this manual and always use a special circuit.
- If the power source capacity is inadequate or electric work is
performed improperly, electric shock or fire may result.