CST Type Remote Controller
Operation
❈ Display temperature can be different from actual room temperature if the remote controller is installed at the
place where sun-rays are falling directly or the place nearby heat source.
Note : 06 Model - AMNH09GTCC0, AMNH12GTCC0
Operation display
Displays the operation conditions.
On/Off Button
Operation starts when this button is pressed, and
stops when the button is pressed again.
Set Temperature Button
Used to set the temperature when the desired temper-
ature is obtained.
FAN Operation Button
Used to circulate room air without cooling or heating.
Fan Speed
Used to set the desired fan speed or select Jet cool
mode.
Operation Mode Selection Button
Used to select the operation mode.
• Auto Operation Mode
• Cooling Operation Mode
• Soft Dry Operation Mode
• Heating Operation Mode(except cooling model)
Auto Swing Button
Used to swing up and down/right and left(option)
Room Temperature Checking Button/Filter sign
Release(Option)
Used to check the room temperature.
Plasma Air Clean Button (Option)/Heater(Option)
Timer Cancel Button
Used to cancel the timer.
Timer Set Button
Used to set the timer when the desired time is
obtained.
Week Button
Usedtosetadayoftheweek.
Program Button
Used to set the weekly timer.
Holiday Button
Used to set a holiday of the week.
Time Set Button
Used to set the time of the day and change the time in
the weekly timer Function.
Set and Clean/Ventilation(Option)
Used to set and clear the weekly timer.
Swirl Button
Used to select swirl mode.
Jet Cool Button
Auto Swing Button(1 Way 06 Model)
Reset Button
Used to set the current time and clear the setting time.
To Next Page
Loading...
Need help?
General
