LG ARUN40LS2A - SELECT THE BEST LOCATION

7
ENGLISH
Transporting the Unit
- When carrying the suspended, unit pass the ropes between legs of
base panel under the unit.
- Always lift the unit with ropes attached at four points so that impact
is not applied to the unit.
- Attach the ropes to the unit at an angle of 40° or less.
- Use only accessories and parts which are of the designated specifica-
tion when installing.
* Product appearance may be different depending on model.
Air outlet grille Intake hole
Corner
Handle
Always hold the unit by the corners, as holding
it by the side intake holes on the casing may
cause them to deform.
Sub line
40° or less
A
WARNING
CAUTION
Be very careful while carrying the product.
• Do not have only one person carry product if it is more than 20
kg.
• PP bands are used to pack some products. Do not use them as a
mean for transportation because they are dangerous.
• Do not touch heat exchanger fins with your bare hands. Other-
wise you may get a cut in your hands.
• Tear plastic packaging bag and scrap it so that children cannot
play with it Otherwise plastic packaging bag may suffocate chil-
dren to death.
• When carrying in Outdoor Unit, be sure to support it at four
points. Carrying in and lifting with 3-point support may make Out-
door Unit unstable, resulting in a fall.
!
SELECT THE BEST LOCATION
1 Select space for installing outdoor unit, which will meet the follow-
ing conditions:
- No direct thermal radiation from other heat sources
- No possibility of annoying neighbors by noise from unit
- No exposition to strong wind
- With strength which bears weight of unit
- Note that drain flows out of unit when heating
- With space for air passage and service work shown next
- Because of the possibility of fire, do not install unit to the space
where generation, inflow, stagnation, and
leakage of combustible gas is expected.
- Avoid unit installation in a place where acidic solution and spray
(sulfur) are often used.
- Do not use unit under any special environment where oil, steam
and sulfuric gas exist.
- It is recommended to fence round the outdoor unit in order to pre-
vent any person or animal from accessing the outdoor unit.
- If installation site is area of heavy snowfall, then the following di-
rections should be observed.
Make the foundation as high as possible.
Fit a snow protection hood.
2 Select installation location considering following conditions to avoid
bad condition when additionally performing defrost operation.
- Install the outdoor unit at a place well ventilated and having a lot of
sunshine in case of installing the product at a place with a high hu-
midity in winter (near beach, coast, lake, etc).
(Ex) Rooftop where sunshine always shines.
- Performance of heating will be reduced and preheat time of the in-
door unit may be lengthened in case of installing the outdoor unit
in winter at following location:
Shade position with a narrow space
Location with much moisture in neighboring floor.
Location with much humidity around.
Location where ventilation is good.
It is recommended to install the outdoor unit at a place with a lot
of sunshine as possible as.
Location where water gathers since the floor is not even.
3 When installing the outdoor unit in a place that is constantly ex-
posed to a strong wind like a coast or on a high story of a building,
secure a normal fan operation by using a duct or a wind shield.
- Install the unit so that its discharge port faces to the wall of the
building.
Keep a distance 500mm or more between the unit and the wall
surface.
- Supposing the wind direction during the operation season of the
air conditioner, install the unit so that the discharge port is set at
right angle to the wind direction.
Air inlet grille
500
Strong
wind
Strong
wind
Blown
air
Turn the air outlet side toward the
building's wall, fence or windbreak
screen.
Set the outlet side at a right angle
to the direction of the wind.