Why LG ATNH36GNLE2 Air Conditioner does not cool or heat effectively?
Ineffective cooling or heating could be due to an incorrect temperature setting. Also, check if the air inlet or outlet vents of the indoor unit are obstructed.
What to do if filter sign lamp (LED) is ON on my LG ATNH36GNLE2 Air Conditioner?
If the filter sign lamp (LED) is on, clean the filter. After cleaning, press the Timer button and the '?' button on the wired remote controller simultaneously for 3 seconds.
What to do if my LG ATNH36GNLE2 Air Conditioner does not operate?
First, check if you've made any mistakes in setting the timer. Also, verify whether a fuse has blown or if the circuit breaker has been tripped.
What to do if error code occurred on LG ATNH36GNLE2 Air Conditioner after lightning struck?
The error code appeared because the over current protection circuit has been activated. This is normal behavior, and the unit should operate normally after a few minutes.
Why LG ATNH36GNLE2 does not operate for about 3 minutes when restart?
The air conditioner's delay in restarting is due to a built-in mechanism protector. Please wait approximately three minutes, and the operation will begin automatically.
General| Heating Capacity | 4.0 kW |
|---|---|
| Refrigerant | R32 |
| Type | Split Air Conditioner |
| Power Supply | 220-240V, 50Hz |
| Indoor Unit Noise Level | 19 dB(A) (Low) |
To Next Page
![Preview: LG ATNH24GPLED[UT24 NPD]](https://data.easymanua.ls/products/561090/200x200/lg-atnh24gpled-ut24-npd.webp)