INSTALLATION GUIDE AT THE SEASIDE
19
ENGLISH
Selecting the location(Outdoor Unit)
1 If the outdoor unit is to be installed close
to the seaside, direct exposure to the sea
wind should be avoided.
Install the outdoor unit on the opposite
side of the sea wind direction.
2 In case, to install the outdoor unit on the
seaside, set up a windbreak not to be ex-
posed to the sea wind.
- It should be strong enough like concrete
to prevent the sea wind from the sea.
- The height and width should be more
than 150% of the outdoor unit.
- It should be keep more than 70 cm of
space between outdoor unit and the
windbreak for easy air flow.
3 Select a well-drained place.
- Periodic ( more than once/year ) cleaning
of the dust or salt particles stuck on the
heat exchanger by using water
INSTALLATION GUIDE AT THE SEASIDE
CAUTION
• Air conditioners should not be installed
in areas where corrosive gases, such as
acid or alkaline gas, are produced.
• Do not install the product where it could
be exposed to sea wind (salty wind) di-
rectly. It can result corrosion on the
product. Corrosion, particularly on the
condenser and evaporator fins, could
cause product malfunction or inefficient
performance.
• If outdoor unit is installed close to the
seaside, it should avoid direct exposure
to the sea wind. Otherwise it needs ad-
ditional anticorrosion treatment on the
heat exchanger.
!
To Next Page
Loading...
