Function Code conversion mode value
Press button for 4 seconds
to enter the installer setting
mode until timer segment
display “01:01”.
1
Press button to exit or
system will automatically exit
after 25 seconds without any
input.
5
Repeat pressing button to select
Function code 12.
Ex) Fahrengeit Setting
2
Select Temperature unit mode by
pressing button.
(00: Celsius, 01: Fahrenheit)
3
Press button to save or release.
4
This function is used for switching the display between Celsius and Fahrenheit.
(Optimized only for U.S.A)
❊ Whenever press button in Fahrenheit mode, the temperature will increase/drop 2
degrees.
1. Wired Remote Controller
To Next Page
Loading...
