Operating 25
Operating
3
Radio Operations
Connect the supplied FM antenna for listening to the
radio. (Page 16)
Listening to the radio
1. Press F until FM appears in the display window.
The last received station is tuned in.
2. Auto tuning :
Press and hold TUNING -/+ on the remote
control or C/V on the unit for about two
seconds until the frequency indication starts to
change, then release. Scanning stops when the
unit tunes in a station.
Or
Manual tuning :
Press TUNING -/+ on the remote control or
C/V on the unit repeatedly.
3. Adjust the volume by pressing VOL +/- on the
remote control or by rotating volume knob on the
unit repeatedly.
Improving poor FM reception
Press N. This will change the tuner from stereo to
mono and usually improve the reception.
Presetting the Radio Stations
You can preset 50 stations for FM.
Before tuning, make sure to turn down the volume.
1. Press F until FM appears in the display window.
2. Select the desired frequency by pressing
TUNING -/+ on the remote control or
C/V on the unit.
3. Press JUKEBOX / MEMORY on the remote control.
A preset number will blink in the display window.
4. Press PRESET·FOLDER W/S on the remote
control to select the preset number you want.
5. Press
JUKEBOX / MEMORY
on the remote
control. The station is stored.
6. Repeat steps 2 to 5 to store other stations.
7. To listen a preset station, press
PRESET·FOLDER W/S or 0 to 9 numerical
buttons on the remote control.
Deleting all the saved stations
1. Press
DELETE
on the remote control.
“DEL ALL” will flash up on the unit display.
2. Press
DELETE
on the remote control to erase all
the saved radio stations.
“DELETED ALL” will flash up on the unit display.
To Next Page
Loading...
Need help?
General
