Operating 25
Operating
3
Radio Operations
Be sure that FM antenna is connected. (Page 16)
Listening to the radio
1. Press F until the FM appears in the display
window.
The last received station is tuned in.
2. Auto tuning :
Press and hold TUNING-/+ on the remote control
or
C
/
V
on the unit for about two seconds
until the frequency indication starts to change,
then release. Scanning stops when the unit tunes
in a station.
Or
Manual tuning :
Press TUNING-/+ on the remote control or
C
/
V
on the unit repeatedly.
3. Adjust the volume by pressing VOL +/- on the
remote control or rotating MASTER VOL. /
MULTI knob on the unit repeatedly.
Improving poor FM reception
Press
N
. This will change the tuner from stereo to
mono and usually improve the reception.
Presetting the Radio Stations
You can preset 50 stations for FM.
Before tuning, make sure to turn down the volume.
1. Press F until the FM appears in the display
window.
2. Select the desired frequency by pressing
TUNING -/+ on the remote control or
C
/
V
on the unit.
3. Press JUKEBOX/MEMORY on the remote
control. A preset number will blink in the display
window.
4. Press PRESET·FOLDER
W
/
S
on the remote
control to select the preset number you want.
5. Press JUKEBOX/MEMORY on the remote
control. The station is stored.
6. Repeat steps 2 to 5 to store other stations.
7. To listen a preset station, press
PRESET·FOLDER
W
/
S
or 0 to 9 numerical
buttons on the remote control.
Deleting all the saved stations
1. Press DELETE on the remote control.
“DEL ALL” will flash up on the unit display.
2. Press DELETE on the remote control to erase all
the saved radio stations.
“DELETED ALL” will flash up on the unit display.