Operating 17
Operating
3
Radio Operations
Be sure that FM/AM aerial is connected.
(Refer to the page 13)
Listening to the radio
1. Press FUNCTION on the remote control or
FUNC. on the unit until FM/AM appears in the
display window.
The last received station is tuned in.
2. Auto tuning : Press TUNING -/+ on the remote
control or
Y/U
on the unit for about 2
seconds until the frequency indication starts
changing, then release. scanning stops when
the unit tunes in a station.
Manual tuning: Press TUNING -/+ on the
remote control or
Y/U
on the unit
repeatedly.
3. Adjust the volume by pressing VOL +/- on the
remote control or by rotating volume knob on
the unit repeatedly.
Presetting the Radio Stations
You can preset 50 stations for FM/AM.
Before tuning, make sure to turn down the volume.
1. Press FUNCTION on the remote control or
FUNC. on the unit until FM/AM appears in the
display window.
2. Select the desired frequency by pressing
TUNING-/+ on the remote control or
Y/U
on the unit.
3. Press PROGRAM/MEMORY. A preset number
will blink in the display window.
4. Press PRESET·FOLDER
W
/
S
to select the
preset number you want.
5. Press PROGRAM/MEMORY. The station is
stored.
6. Repeat steps 2 to 5 to store other stations.
7. To listen to a preset station, press
PRESET·FOLDER
W
/
S
or 0 to 9 numerical
buttons.
Deleting all the saved stations
1. Press and hold PROGRAM/MEMORY for two
seconds. “ERASEALL” will blink in the unit display.
2. Press PROGRAM/MEMORY to erase all saved
radio stations.
Improving poor FM reception
Press
d
/
M
on the remote control or
T
ST./MO.
on the unit. This will change the tuner from stereo
to mono. Then the reception will be better than
before.
CM4230_AU.DPANLLK ENG 7527.indd 17CM4230_AU.DPANLLK ENG 7527.indd 17 2013-03-06 9:28:092013-03-06 9:28:09
To Next Page
Loading...
