POWER ON
FLD “NO DISC” status
It is possible at any function.
(ex. It is possible at FLD “NO USB” status, too.)
This is an example.
Remote control ‘ ’ + Front ‘STOP’
push same timing during 5 seconds.
FLD “op0-…..”
Move to appropriate position and
make changes with remote control.
( , , /■ , REPEAT )
Press STOP key
FLD “WRITE OK”
Remote control ‘ ’ +
Front ‘STOP’ push same timing.
FLD “e2p clr”
Completed
NAME
OP0
OP1
OP2
OP3
OP4
OP5
OP6
OP7
OP8
OP9
DETECT NEW EEPROM
(OPTION EDIT SCREEN)
HEX
05
00
00
00
00
01
81
46
00
01
1-7
SERVICE INFORMATION FOR EEPROM
To Next Page
Loading...
Need help?
General
