-29-
Disassembly, assembly and repairing of main parts
3. How to replace motor assembly
(1) Disassemble the deco-
ration part with a at
headed screwdriver.
(Itwill have to be re-
placed if damaged)
(2) Pull the pipe part with a
hand.
(3) Remove the screws on the
bottom of the pipe.
(4) Pull the pipe part with a
hand.
(5) Remove the connector
from the gasket.
(6) Remove the filter cover
and the filter with a hand.
(7) Remove the gasket of
the body and the motor,
followed by theharness.
(8) Remove the motor from
the body.
(9) Reassemble the whole part
in the reverse sequence.
※ Note:
Use insulating tape if a gasket is damaged
as in the figure whilereplacing the motor.
To Next Page
Loading...
