14
Charging the Battery
1
Put the product on the charging station.
•
The battery indicator has 3 bars to indicate the
charge level. The bars will ash during charging.
2
An auxiliary battery can be charged in the base
of the charging station.
•
The auxiliary charge indicator will ash until
the auxiliary battery is fully charged.
CAUTION
•
Make sure to securely t the unit on to the
charging station. Otherwise, the product may fall
and get damaged.
Note:
•
The battery will not be charged if the ambient
temperature is below 41°F (5°C). Only charge the
battery when ambient temperatures are between 41°F
(5°C) and 100°F (38°C).
•
The battery indicator will turn on if the product is fully
charged, removed from the station, and charged again
soon. After a few minutes, the indicator turns o.
•
If the battery is fully charged, it will not start charging
for 24 hours. When the battery is fully charged, 3 bars
will be lit on the battery indicator. The indicator turns
o a few minutes after the vacuum is placed in the
charging station.
Charging the Auxiliary Battery
(Available on select models only)
1
Remove the spent battery from the product by
pressing in on both sides of the battery and pulling.
2
Insert the battery into the auxiliary charging
station.
Auxiliary
battery charge
indicator
Note:
•
Make sure that the power adapter is connected to
both the charging station and the power outlet
•
If the main battery is charging on the charging
station, the auxiliary battery will only start charging
once the main battery is fully charged.
•
The auxiliary battery indicator ashes when
charging starts.
•
The indicator will stay on when the auxiliary battery
is fully charged.
•
Fully charging a single battery usually takes 3.5
hours. It will take twice as long to charge both the
main and auxiliary batteries.
Adjusting the Suction
Press the Power On/O button to turn the vacuum on
or o.
Press the plus or minus button on the product body
to set the suction strength to Standard, Power, or
Turbo mode.
1
2
1
Power On/O button
•
Press the power On/O button to activate the
Normal mode.
2
Mode button
•
Press plus (+) to switch to Power mode.
•
Press and hold plus (+) to turn on Turbo
mode.
•
It may take a moment to switch from Normal
to Turbo mode.
•
Press minus (-) to switch modes from Turbo >
Power > Normal.
To Next Page
Loading...
