During Healthy Dehumidification Operation
❏ If you select the dehumidification mode on the OPERATION MODE
SELECTION BUTTON, the product starts to run the dehumidification function.
It automatically sets the room temperature and airflow volume to the best
condition for dehumidification, based on the sensed current room temperature.
In this case, however, the setting temperature is not displayed on the remote
controller and you are not able to control the room temperature either.
❏ During the healthy dehumidification function, the fan speed is automatically set
according to the optimization algorithm responding to the current room
temperature status, so that the room condition is kept healthy and comfortable
even in the very humid season.
Operating Instructions
<For Cooling Model>
The temperature and fan speed are automatically set by the electronic controls based on the
actual room temperature.
If you feel hot or cold, press TEMPERATURE SETTING buttons for more cooling or heating effect.
You cannot switch the indoor fan speed. It has already been set by the Auto Operation Mode rule.
Auto Operation (Multi Air Conditioner)
Healthy Dehumidification Operation
This operation is basically heating or cooling function of the air
conditioner. But during this operation the controller changes the
operation mode automatically to keep the temperature within
±2°C with respect to the setting temperature.
Auto Changeover Operation (Single Air Conditioner)
You can set desired temperature and indoor fan speed.
Setting Temp. Range : 18~30°C.
: You can not set the actual setting temperature and the fan speed in
this operation mode ,But you can use the Auto swing in this
operation. If the system is not operating as desired,switch manually
to another mode
To Next Page
Loading...
Need help?
General
