18 INSTALLATION
2 While supporting the door, remove the 2
screws on the door hinge. Remove the door.
3 Turn the door upside down and line up the
holes in the hinge with the holes on the
opposite side of the cabinet. Reinstall the
door with the screws removed in step 2.
• Be sure to support the weight of the door before
inserting the hinge screws.
4 Install the 2 decorative screws, the latch, and
2 latch screws removed in step 1 on the
opposite side from which they were removed.
5 Check that the door closes properly.
Door Reversal Instructions
(DL*X450**)
The instructions here are for changing the door
swing from a right to a left side hinge. If the door
has been reversed, and it is necessary to change it
back, use care when following these instructions.
Some of the illustrations and the left/right
references will be reversed, and you will need to
read the instructions carefully.
1 Open the appliance door.
2 You will be removing the screws shown below
(6 on left, 4 on right).
3 Remove the four decorative screws on the left
using a screwdriver.
4 Remove the two latch screws and the latch.
To Next Page
Loading...
Need help?
General
