49
1. Open the door so that the hinge screws are accessible.
2. While supporting the door, remove the four hinge screws, two
from each hinge. Set the door aside face down on a protected
surface to prevent damage to the door or the work surface.
screwdriver, being careful not to scratch the paint. Install the latch
hole cover on the opposite side, where the latch mechanism was
removed. Install the latch mechanism in the position from which you
removed the latch hole cover, using the two screws removed in step 3.
screwdriver, being careful not to scratch the paint. Rotate the hinge
cover 180 degrees and install it on the opposite side, where the upper
hinge was attached.
THE DRYER DOOR IS VERY LARGE AND HEAVY. Failure to follow the
instructions below can result in damage to the dryer, property damage
or personal injury. The edges of the door cover may be sharp. Take care
when handling, or wear gloves to avoid injury.
Be sure to support the weight of the door before removing the
hinge screws.
Use a Phillips screwdriver to remove the two screws and the latch
mechanism on the front panel of the cabinet.
5.
2
6. Reverse the hinge and the hinge bracket at the bottom of the cabinet.
Remove the two screws from the hinge bracket at bottom right and
remove the hinge bracket.
Remove the lower of the two screws behind the hinge bracket.
Do NOT remove the upper screw behind the hinge bracket.
Set the parts aside.
7. Remove the three screws on the hinge at bottom left.
Remove the hinge and reinstall it on the right side.
The top screw occupies the hole where you removed the screw
behind the hinge bracket in step 6.
8. Install the hinge bracket removed in step 6 on the bottom left side,
9. With the door laid inside facing up on a protected surface, remove the
Φ5 screw
10. Remove the four screws on the door
cover that secure The door strike and
the blank cover.
Switch the door strike and the blank
cover, installing them on the opposite
sides from which they were removed.
Set the door cover aside.
Long screw Short screw
Cap
To Next Page
Loading...
Need help?
General