2-2.
Reconnect the another duct[11 in(28cm)] to the
blower housing, and attach the duct to the
base. ( Duct is a SVC part)
2-1.
Detach and remove a knockout at the botton,
left or right side as desired. (Right Side Vent not
available on Gas dryer)
, , the order of work.
3-1.
Pre-assemble 4" elbow with 4" duct.
Wrap duct tape around joint.
3-2.
Insert elbow duct assembly first through the
side opening and connect the elbow to the
internal duct.
To Next Page
Loading...
Need help?
General
